The iterative procedure followed is shown in the lab notes below. At this stage in the calibration the slope was set to 19.95mv/dB.
08 March 2014
Calibrating the slope of the AD8307 Power meter
The first task after building the Power meter was to adjust the Calibration output (Port B) pot to as close as possible to the specified 20mV/dB.
The iterative procedure followed is shown in the lab notes below. At this stage in the calibration the slope was set to 19.95mv/dB.
The iterative procedure followed is shown in the lab notes below. At this stage in the calibration the slope was set to 19.95mv/dB.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment